All In One HID Xenon Kit
Standard configuration for all in one HID xenon kit.

Two ballast, two original light bulb(equipped with universal light bulb ), fixed steel hoop (equipped with soft rubber set ), one instruction book, one warranty card
Ballast voltage: 35W
Model for HID bulb: Choose from the existing model
Packaging: Luxurious packaging

The features for integration xenon lamp kit.
1. Easy installation, no damage to the original car parts.
2. Do not need outer wire connector, just fixed in the headlight assembly.
3. Slim and light patented product give you excellent performance.

Streamline appearance and good construction design and usable for most type of cars.

Available lamp model: 9005, 9006, H1, H3, H4, H7, H8, H9, H11, H13.
Technical parameters for integration ballast.
1. Input voltage: 9-16V
2. Input stable current: 3.5A± 0.2A
3. Cold start current: 4.0A± 0.1A
4. Warm start current: 3.6A± 0.2A
5. Starting time: 10S± 1S
6. Over voltage protection: 18V
7. Low-voltage protection: 7V-9.5V
8. Open circuit protection: 1-2S
9. Short circuit protection: 1-2s
10. Output power: 33W± 2W

Installation steps for 9005 9006 all in one HID xenon kit.
Un snatch the dirt-proof boot and bulb of original car.
Install the integration bulb.

Installation steps for soft plastic cover special car all in one HID xenon kit.
1. Un snatch the dirt-proof boot and bulb of original car.
2. Install the integration bulb.
3. Connect hosts line and the assembly power cord.
4. Fix the ballast in the headlight assembly with steel hoop,

Installation steps for hard plastic cover universal type all in one HID xenon kit.
1. Un snatch the dirt-proof boot and bulb of original car.
Install the integration bulb.
2. Open a hole of 22 mm diameter on the water proof cover with special punch, set on the water proof ring and fix the ballast on the water proof cover then tighten the screws.
3. Set on the dust set and fixed the reinforced part.